SUGGESTED USE
EZ-Clean GI quickly removes lubricating oils and greases from affected surfaces. FOR YOUR PROTECTION, WEAR SAFETY GLASSES WHEN USING EZ-CLEAN GI. NOTE: Do not allow the product to dry on surface. DO NOT ALLOW EZ-Clean GI TO FREEZE. Please take precautions and use the recommendations in the Material Safety Data Sheet
DIRECTIONS
- Moping: EZ-Clean GI can be diluted 10:1 with water when mopping.
- Heavy Equipment and Machinery: (full strength- 4:1, depending on the soiled area): Spray on and let stand or agitate for 1-2 minutes then wash off.
- Concrete Floors: (full strength- 8:1, depending on soiled area): Spray on, agitate with brush or mop, and rinse. Rubber and Plastic (dilute 10:1 or stronger, depending on the soiled area): Spray on, agitate with brush, and rinse.
- Hot Water Pressure Washers: (Full strength- 20:1 depending on soiled area): Spray the EZ-Clean GI on the equipment and spray off with steam pressure washer.
|
EZ-Clean GI is a water-based, super-concentrated cleaner/degreaser which is biodegradable and non-flammable. Designed to remove dirt, oils and greases from surfaces such as floor, machinery, stamping dyes, plastics and rubber, EZ-Clean GI is strong enough to tackle even the toughest of soils without harming the actual floor or machinery surface. With a pH of over 13.5, its ingredients cling to surfaces and begin emulsifying soils on contact causing the soil to become part of the solution. It also contains agents which prevent the soil from redepositing on the surface while cleaning.
